← All tools

Jig Builder

by LZRsuite · Batch jigs for LightBurn Print & CutCO₂ & diode · jigs in wood or acrylic

Product

Jig sheet

The jig is the whole sheet, the size you'll cut it from.

Pockets

The cut runs half a kerf inside each pocket, so the hole comes out the product plus the clearance all round.

Finger notches

Marks and words

Artwork (optional)

Drop your artwork, or click to choose (SVG, PNG or JPEG)

Add your art and the job file puts a copy in every pocket, centred on each product.

Files

SVG at true size. Cut a test pocket from scrap first to check the fit.

Lining it up in LightBurn

Cut the jig (once)

  1. Open the jig file. Black engraves the marks (Fill), red scores (low power), blue cuts through. Gray is the sheet's outline: turn its output off.
  2. Run black and red before blue, so nothing moves once the pockets drop out.
  3. Once it's cut, turn blue into a guide so it can't cut again: Shift-click the blue layer in Cuts / Layers to select every pocket, then click T1 at the end of the color palette. T1 is a tool layer: it never goes to the laser, but the pockets stay on screen for reference and for placing your art. They line up as long as the jig stays where it was cut.

Engrave a batch

  1. Put the jig on the bed and the products in their pockets. It doesn't need to sit where it was cut.
  2. Open the job file. Gray is guides: turn its output off.
  3. Camera Print & Cut (LightBurn 2.2 or later, with a head camera): Window → Camera Print & Cut, Mark layer magenta (its output turns off by itself). Jog until the camera sees mark 1, the square at the top left, and press Find Marks. Pick “Keep size”: the jig was cut on this laser, true to size.
  4. Or Print & Cut with the red dot: turn the magenta layer's output off, then Laser Tools → Print and Cut → Start Wizard. Select mark 1 (top left square), jog the red dot onto its centre, Set. Select mark 4 (bottom right), Jog To Selection, fine-tune, Set. Align with no scaling.
  5. Frame it, then run.
Jig

About Jig Builder

What is a laser jig for?

Engraving a whole batch at once. The jig holds every piece in its own pocket, registration marks let LightBurn line the job up with it, and the job file puts your art in every pocket, centred on each product.

How snug are the pockets?

Snug, standard or loose. The cut runs half a kerf inside each pocket, so the hole comes out the product plus the clearance all round. Cut a test pocket from scrap first to check the fit.

How do I line it up in LightBurn?

Cut the jig once: black engraves the marks, red scores, blue cuts through. Then put the products in their pockets, open the job file, and use Camera Print & Cut (LightBurn 2.2 or later, with a head camera) or Print & Cut with the red dot.

What does it cost?

Jig Builder comes with the Maker and Pro plans. Try it free; saving needs a plan.